1.32 OLED Display Module (128×96)

This OLED module is great for adding a small display to your project, with enough room for info from your robot, 3D printer, API or other data source.

The display is 1.32′ diagonal, with 128×96 pixels and an embedded SSD1327 controller offering both a 4-wire SPI and I2C interface for maximum compatibility.

The display comes with a matching 7-pin cable for connecting to your microcontroller of choice. Raspberry Pi, Arduino and STM32 examples are provided in the online wiki.

Note: the display ships with 4-wire SPI mode enabled by default. Changing the mode to I2C, or changing the address, requires careful desoldering and movement of the small SMT resistors on the rear (not for beginners!). If you need I2C and you aren’t handy with SMT soldering, we suggest opting for a dedicated I2C OLED module instead.

Connection Example – Raspberry Pi (SPI)

Connection Example – Arduino (SPI)

Features

• 1.32′ OLED display
• Ultra-narrow bezel
• Compact size
• Onboard voltage translator
• 4-wire SPI (default) and I2C interfaces (setting to I2C requires SMT soldering)
• Online development resources (examples for Raspberry Pi/Arduino/STM32)

Specifications

Operating Voltage	3.3V / 5V
Resolution	128 x 96 pixels
Communication Interface	4-wire SPI / I2C
Display Size	26.86 x 20.14mm
Display Panel	OLED
Pixel Size	0.19 x 0.19mm
Driver	SSD1327
Module Size	34.30 x 30.50mm

Resources

• Product Wiki

Pinout

RES	Reset, low active
DC	Data/Command selection (high for data, low for command)
CS	Chip selection, low active
CLK	Clock input
DIN	Data input
GND	Ground
VCC	Power (3.3V / 5V input)

Package Contents

• 1x 1.32′ OLED Module
• 1x GH1.25 7-pin cable