1.8 LCD display Module (128×160)

Looking for a small, full-colour, display for your next project? This little 1.8-inch general-purpose LCD display module, features a resolution of 128×160 pixels, with an embedded controller, and communication via SPI. This is an ideal display for your next Arduino, Adafruit HUZZAH, or Raspberry Pi project. 

Features

• SPI interface requires minimum GPIO for controlling
• Comes with development resources and manual (examples for Raspberry Pi/Jetson Nano/Arduino/STM32)

Specifications

• Driver: ST7735S
• Interface: SPI
• Display color: RGB, 65K color
• Resolution: 128×160
• Backlight: LED
• Operating voltage: 3.3V

Resources

• Waveshare Wiki

Package Contents

• 1x 1.8′ LCD Module
• 1x PH2.0 20cm 8-Pin

Dimensions

Interface 

• VCC: Power (3.3V input)
• GND: Ground
• DIN: SPI data input
• CLK: SPI clock input
• CS: Chip selection, low active
• DC: Data/Command selection (high for data, low for command)
• RST: Reset, low active
• BL: Backlight